- Joined
- May 7, 2012
- Messages
- 108
- Points
- 1,601
- Age
- 31
- City
- Shelby, NC
- Vehicle Year
- 1984/8 mix
- Transmission
- Manual
I'm looking to swap the 2.9 out cause its the devil, what parts would be interchangable on the motors?
Interchangeable parts between 2.9 and 4.0 engines
- Thread starter Pbheadshots
- Start date
- Joined
- Dec 10, 2008
- Messages
- 2,512
- Points
- 3,101
- Age
- 51
- City
- Stillwater, OK
- Vehicle Year
- 1990,92
- Transmission
- Manual
None. You will want the thicker 4.0 radiator. The 4.0 tranny. But all the other stuff will not interchange
- Joined
- May 7, 2012
- Messages
- 108
- Points
- 1,601
- Age
- 31
- City
- Shelby, NC
- Vehicle Year
- 1984/8 mix
- Transmission
- Manual
You sure?
- Joined
- Apr 13, 2009
- Messages
- 16,132
- Points
- 3,101
- Vehicle Year
- '06, '11
- Engine
- 3.0 V6
- Transmission
- Automatic
IIRC Exhaust manifolds swap according to plumcrazy.
Richard
Richard
- Joined
- Dec 10, 2008
- Messages
- 2,512
- Points
- 3,101
- Age
- 51
- City
- Stillwater, OK
- Vehicle Year
- 1990,92
- Transmission
- Manual
The alts arent the same, you might get by with a pulley swap on the powersteeringpump, but what are you wanting to exchange?
- Joined
- May 7, 2012
- Messages
- 108
- Points
- 1,601
- Age
- 31
- City
- Shelby, NC
- Vehicle Year
- 1984/8 mix
- Transmission
- Manual
I was planning on keeping my original transmission and transfer case and radiator, honestly I'm factoring in the cost for the swap.
- Joined
- Aug 7, 2007
- Messages
- 2,243
- Points
- 3,101
- Age
- 54
- City
- Farmington Il.
- Vehicle Year
- 1988
- Transmission
- Automatic
- Joined
- Apr 13, 2009
- Messages
- 16,132
- Points
- 3,101
- Vehicle Year
- '06, '11
- Engine
- 3.0 V6
- Transmission
- Automatic
I haven't mixed and matched parts personally, but from reading through the forums and tech section [hint], it seems the tranny can be used with the right mix.
The rad probably could be used if in good shape.
The exhaust manifolds, or headers, could be used but there will be cut and weld on the y-pipe or source the correct one.
Alternator wiring, the wire ends can be swapped for the correct ones with a little thought and /or research.
It seems the hardest part is combining the two wiring harnesses, as there is differences.
Good luck,
Richard
The rad probably could be used if in good shape.
The exhaust manifolds, or headers, could be used but there will be cut and weld on the y-pipe or source the correct one.
Alternator wiring, the wire ends can be swapped for the correct ones with a little thought and /or research.
It seems the hardest part is combining the two wiring harnesses, as there is differences.
Good luck,
Richard
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
