- Joined
- Mar 18, 2011
- Messages
- 11
- Points
- 1,601
- Vehicle Year
- 2000
- Transmission
- Manual
2000 Ranger, 2WD, no cruise. I replaced the master cylinder with a Fenco NM3071. The new master cylinder comes with the o-ring for the control or proportioning valve that threads into the side of the master cylinder.
After reassembly, the joint where the valve attaches to the master cylinder leaks a little. Thinking the master cylinder or o-ring were bad, I did it again - new master cylinder, new o-ring. It's better now, but it still leaks.
I emailed Fenco, they weren't much help, said it "can't leak". I'm wondering if the o-ring might be slightly undersize for the application.
Anyone have this problem before? Any thoughts on how to fix it?
Thanks.
After reassembly, the joint where the valve attaches to the master cylinder leaks a little. Thinking the master cylinder or o-ring were bad, I did it again - new master cylinder, new o-ring. It's better now, but it still leaks.
I emailed Fenco, they weren't much help, said it "can't leak". I'm wondering if the o-ring might be slightly undersize for the application.
Anyone have this problem before? Any thoughts on how to fix it?
Thanks.
