- Joined
- Oct 29, 2010
- Messages
- 10
- Points
- 1,601
- Vehicle Year
- 1999
- Transmission
- Manual
My clutch goes flat after a couple of days in my 1999 ranger 3.0 2WD. I did the bench bleeding of a new master cylinder and installed it. I also bleed the slave. After the bleeding, pedal gets hard and everything is fine but pedal goes soft in few days and I can't shift gears. No sign of oil leak but I think I have some air leak in some line that goes to slave. I am getting ready to take down the transmission but don't realy know what to look for to fiind the leak. Is it possible that slave is bad? A new clutch kid was installed by a shop last year but I don't know if they changed the slave. I appreciate any advise and ideas to solve this problem. Thank you
