- Joined
- Feb 9, 2008
- Messages
- 12
- Points
- 3,101
- Vehicle Year
- 89
- Transmission
- Manual
james duff makes a single traction bar for the big broncos that goes up the center and welds to the crnter housing.. looks like a great concept. it will block bigget stuf from bashing your shaft. It also looks more productive than those bars that bolt to the wheelwells or ladders that limit travle.. i looked at my 8.8 on my bII and theres a great spot to burn a brkt on the drivers side. has any one tryd this on a bII?? im running my stock leafs and the block that was on the 8.8 that i pulled from a range and im getting too much wrap. It binds up then i chomp on it in first on the asphalt. any one have any insite check out the bar on duffs site if you dont know what im talking
about. thanks,Ben.
about. thanks,Ben.
