skid plates and tranny cross member

BRONCONUT · Dec 31, 2011

Here are the skid plates and tranny cross member I have made for my FSB.

I will start it off with the gas tank skid...

BRONCONUT · Dec 31, 2011

BRONCONUT · Dec 31, 2011

and now for the tranny x-member...

BRONCONUT · Dec 31, 2011

and the t- case skid that bolts to it...

jhammel85 · Dec 31, 2011

Fantastic work! Good job man..

disciplerocks · Dec 31, 2011

Looks like you lost a little clearance, but I guarantee nothing you bash that against will hurt it. Nice job man.

escort_gts · Dec 31, 2011

Yes. That is impressive work.

Sent from my HTC using Tapatalk

BRONCONUT · Jan 2, 2012

Installed gas tank skid pics were added to the second post.

disciplerocks said:
Looks like you lost a little clearance, but I guarantee nothing you bash that against will hurt it. Nice job man.

I dont think that I lost any clearance with either. The skid on the gas tank is tight and the back corner is about an inch past the springs. The t-case is about 1" from hitting the skid plate there, if lost any it is a very small amount. My Bronco has enough ground clearance for most anything I go through around here.

Here are a couple pics of it, I did not get the suspension maxed out in any of these pics.

I have roughly around 9"of lift maybe a little more with 37's

skid plates and tranny cross member

BRONCONUT

15+ Year Member

BRONCONUT

15+ Year Member

BRONCONUT

15+ Year Member

BRONCONUT

15+ Year Member

jhammel85

Guest

disciplerocks

July 2011 OTOTM Winner

escort_gts

02/2012 04/2013 04/2014 OTOTM Winner

BRONCONUT

15+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions