PDA

View Full Version : Gear Ratio tag

Joe400
08-25-2007, 10:32 AM
somewhere during the lifetime of my ranger, the tag on the inside of the door that has the axle info, tire pressure, ect. has been peeled off. Is there any other way besides pulling the differential cover off to find out the gear ratio and/or rear end type? Its a '93 4.0 Supercab 4x4
Jspafford
08-25-2007, 10:38 AM
There should be a metal tag bolted to one of the differential cover bolts with the info on it.

It will say like 3L410 or something of the sorts. Get the info and post it up here.
compleckz
08-25-2007, 11:02 AM
as jspafford said, the rear axle should have a tag secured by one of the diff cover bolts.

this page in the tech library should help you identify it:
http://www.therangerstation.com/tech_library/Axles.html

stolen from that page:

http://www.therangerstation.com/tech_library/images/AxleTag.gif
Joe400
08-25-2007, 12:18 PM
I forgot to mention that the tag was so rusted that i couldn't read anything. It basically just fell apart when i tried to read it. Just one of the many problems of living in the rust belt.. is there any way to tell what it is from the VIN number?
brendank
08-25-2007, 12:57 PM
Not sure about the vin. Why don't you just peel the cover off and check the numbers stamped on the ring gear? Or worst case, you can count the teeth and figure it out.
baddis
08-25-2007, 01:01 PM
mark a tire and the driveshaft and turn the ds and it will give you a rough idea so if you turn the drive shaft 3 and 3/4 you would have 3.73 or 3 and 1/2 would be 3.45 and so on
compleckz
08-25-2007, 04:37 PM
there should also be a sticker on the inside of pass side ttb arm, it will tell u the gear ratio... or do what baddis said, and that will also tell u if u have a l/s rear (if both tires spin the same direction its l/s, opposite = open)..

heres 7.5 vs 8.8
http://www.therangerstation.com/tech_library/images/7and8.JPG
alain
08-27-2007, 10:22 AM
Not sure about the vin. Why don't you just peel the cover off and check the numbers stamped on the ring gear? Or worst case, you can count the teeth and figure it out.


Yes, and your freindly Ford Part dealer should check that for you easily
Jspafford
08-27-2007, 10:59 AM
Yes, and your freindly Ford Part dealer should check that for you easily

Good luck with that.:haha:
ZSK
08-27-2007, 01:46 PM
Sounds like the perfect time to put fresh lube in the rear end. Pull the cover drain the old lube and at the same time you can check the type of rear and the ratio.