View Full Version : help with roll bar and pushbar
02-21-2008, 08:58 PM
Would a Smittybuilt black 3" double front/single rear tube roll bar; it was mounted in an 87 Ranger long bed fit my ranger 99 xlt
i also have a question about if a Ford push bar with brush guards, it was for an 90 style Ranger front end would fit on my 99 ranger xlt
02-21-2008, 10:28 PM
Your rollbar should work, there isn't too many variables to mess up on it. Different bed lengths might get you though, you could always set it in the back and see were the rear supports land, normally they go on the wheel well but some are actually supposed to go to the floor of the bed. My double tube Smittybilt lands on the wheel wheels.
I doubt the grilleguard would fit without some modifications and if you made it fit you probably couldn't use the brushgaurds infront of the lights.
02-26-2008, 10:54 PM
I don't want to highjack this post but will a grizzly rollbar that was on a ford edge fit in my ford step side xlt 2001 short box
vBulletin® v3.8.6, Copyright ©2000-2013, Jelsoft Enterprises Ltd.