- Joined
- Nov 29, 2009
- Messages
- 1,377
- Points
- 3,101
- City
- Sheridan, CA
- Vehicle Year
- 1986
- Transmission
- Manual
I kinda want to the slider back window in. How easy is it to do? And would it be better to order it from lmc or get it from a jy?
keep the back flass
- Thread starter 86MUDRCJ
- Start date
- Joined
- Dec 1, 2007
- Messages
- 689
- Points
- 3,101
- City
- Lake Almanor, Ca.
- Vehicle Year
- 1988/2000
- Total Lift
- 9" on the 2000, 6" on the '88
- Tire Size
- 265/75/16, 31x10.50x15
- My credo
- The memories of a man in his old age are the deeds of a man in his prime
It's easy to do with a pliable gasket. I put one in my truck ages ago, it was new. You might be able to find a good one at the jy. I did rebuild one that is in my camper shell.
Rich
Rich
- Joined
- Nov 29, 2009
- Messages
- 1,377
- Points
- 3,101
- City
- Sheridan, CA
- Vehicle Year
- 1986
- Transmission
- Manual
Is it so easy a caveman can do it? If it is then ill give it a shot.
- Joined
- Aug 19, 2007
- Messages
- 6,656
- Points
- 3,101
- Age
- 37
- City
- Everett, WA
- Vehicle Year
- 2012
- Transmission
- Automatic
Easy. Pull the trim panels from the inside and that'll expose the few bolts that hold the window in.
- Joined
- Feb 28, 2001
- Messages
- 10,750
- Points
- 7,601
- City
- Dayton
- State - Country
- OR - USA
- Vehicle Year
- 1990, 1997
- Drive
- 4WD
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
- Total Lift
- 6
- Tire Size
- 35"
no nuts on a regular cab, open the door, push out on the top corner until you can get your fingers behind the seal then start pulling, work your way across the top then down the sides and pull up on the whole window. Install is basically the reverse, set it in on the bottom or one side and work the seal in around the ledge. It's a little more difficult with a full interior but my truck didn't come with one 
- Joined
- Feb 28, 2001
- Messages
- 10,750
- Points
- 7,601
- City
- Dayton
- State - Country
- OR - USA
- Vehicle Year
- 1990, 1997
- Drive
- 4WD
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
- Total Lift
- 6
- Tire Size
- 35"
it has to be a regular cab, but I believe they work through '98 as I've noticed they still have that tiny rear window, I wish they had the large extended cab size...
- Joined
- Nov 29, 2009
- Messages
- 1,377
- Points
- 3,101
- City
- Sheridan, CA
- Vehicle Year
- 1986
- Transmission
- Manual
Well it sounds easy enough ill give it a try.
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
