- Joined
- Aug 8, 2007
- Messages
- 93
- Points
- 3,101
- Age
- 42
- City
- Auburn, Maine
- Vehicle Year
- 04
- Transmission
- Automatic
I have a 95 3.0 ex cab 2wd
Front is lowered 4 inches and the rear is a 99 explorer axle with explorer leafs
I cut off the 2piece cross-member and wanted to use my 1pc aluminum 2wd shaft from my sport trac. I can't get the drive-shaft bolted up AND get the leafs in-place, I am MAYBE 1/2 inch too long. Does anyone have a measurement of the stock 1pc that would work? Or is it because of the lowering that it doesn't fit right?
I could probably pay to have this one shorten 1/2 inch or so, but it would be cheaper if a Junkyard stock shaft would fit.
Any help would be great
Thanks!
Scottg
Front is lowered 4 inches and the rear is a 99 explorer axle with explorer leafs
I cut off the 2piece cross-member and wanted to use my 1pc aluminum 2wd shaft from my sport trac. I can't get the drive-shaft bolted up AND get the leafs in-place, I am MAYBE 1/2 inch too long. Does anyone have a measurement of the stock 1pc that would work? Or is it because of the lowering that it doesn't fit right?
I could probably pay to have this one shorten 1/2 inch or so, but it would be cheaper if a Junkyard stock shaft would fit.
Any help would be great
Thanks!
Scottg
