kunar
Forum Staff Member
TRS Forum Moderator
⭐Supporting Member
Article Contributor
TRS Event Participant
V8 Engine Swap
- Joined
- Jun 10, 2003
- Messages
- 4,177
- Points
- 5,101
- City
- Toledo
- State - Country
- OH - USA
- Vehicle Year
- 1987
- Vehicle
- Ford Ranger
- Drive
- 2WD
- Engine
- 351
- Transmission
- Manual
well i noticed today that my rear axle is cast to be able to accept RABS but not machined, there is no hole there. i thought i read somewhere that only the old 8.8 were like this but my axle looks like its a 7.5 i have never seen another 7.5 that was cast but not machined for RABS, and i have not taken the cover off yet so i dont know if there is the internal stuff there or not. do i have a goofy axle?
