- Joined
- Nov 12, 2008
- Messages
- 1,347
- Points
- 3,101
- City
- Nova Scotia Canada
- Vehicle Year
- 1997
- Transmission
- Manual
What regulator do you guys typically use when putting a carbed engine into a fuel injected truck?
Fuel Pump Regulator
- Thread starter Teddyzee
- Start date
- Joined
- Feb 26, 2010
- Messages
- 216
- Points
- 3,101
- City
- West Blocton,Alabama
- Vehicle Year
- 1992
- Transmission
- Automatic
http://www.summitracing.com/parts/HLY-12-803BP/
Worked good for me.
Worked good for me.
- Joined
- Dec 13, 2008
- Messages
- 103
- Points
- 3,101
- City
- Michigan, Bay County
- Vehicle Year
- 1992
- Engine
- 2.9 V6
- Transmission
- Automatic
- Total Lift
- Leveling 2" Lift
- Tire Size
- 31x10.5xR15
- My credo
- BSME, design, drawing
I tried to use the one mentioned by Summit Racing they said it was for a low pressure pump after I tried using it and couldn't return. But, I used the stock 2.9 in-tank pump so I called Holley and go figure they told me to use this Mallory regulator. Mine only decreases the pressure to 6.5 psi though, you may need both (in series) if your pressure is not where you want it? But 6.5 psi works ok so far for me. Just have to buy special fittings ($20 each, ouch) to go from factory type fuel line to npt fittings.
Mallory Ignition 4309 - Mallory Fuel Pressure Regulators
(this is for high pressure efi to carbed pressure reduction)
Mallory Ignition 4309 - Mallory Fuel Pressure Regulators
(this is for high pressure efi to carbed pressure reduction)
85_Ranger4x4
Wallers in rivers
TRS Forum Moderator
TRS Event Staff
Article Contributor
TRS Event Participant
TRS 20th Anniversary
VAGABOND
OTOTM Winner
V8 Engine Swap
- Joined
- Aug 7, 2007
- Messages
- 36,848
- Points
- 2,001
- City
- Frankfort
- State - Country
- IA- USA
- Vehicle Year
- 1985
- Engine
- 5.0
- Transmission
- Manual
- Joined
- Apr 19, 2011
- Messages
- 64
- Points
- 1,601
- City
- gulfport
- Vehicle Year
- 1994
2011
- Transmission
- Manual
thats the one i just ordered for my swap
- Joined
- Nov 12, 2008
- Messages
- 1,347
- Points
- 3,101
- City
- Nova Scotia Canada
- Vehicle Year
- 1997
- Transmission
- Manual
Too bad you had to do all that work to yours before you saw the light.
Muwahaha!!!
No, a friend is rehab-ing my donor car, it will be run with a carb. (1992 Lincoln Mark VII LSC)
But thanks guys, I just wanted an idea what people use, rather than digging into the stock tank or lines to run a mechanical pump or aftermarket electric.
Not sure which way he'll end up going.
Although I know a 5.3 would swap right in.
I just ordered a low pressure electric pump. Was on sale for less than the regulator listed above.
http://www.summitracing.com/parts/MRG-95H/
http://www.summitracing.com/parts/MRG-95H/
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
