- Joined
- Apr 7, 2011
- Messages
- 2
- Points
- 1,501
- Vehicle Year
- 2011
1997
- Transmission
- Manual
- My credo
- If you aint on the edge. Yur takin' up to much space.
Hi, not done this forum thing before, will take time to figure out stuff. need to ask about planned refit of Rngr, excab, 4x, 4.0. Start with brake conversion to disk, I see lots of stuff but I dont need a whole rear end just the brakes swap, is there a distilled artical or done project written up?
To follow is step bed conversion to tanker duty, bed lining to wood staves(old school) driveline upgrades for tow/carry duty over mountains, and some goodies-audio, phone, variable load springs, task built ladder bar, battery move to rear, and lighting convert to led. Miss anything, probably.
But for now I need to get through the disk conversion without a swap out if possible. And I read conflicting reports about master cylinder upgrades; some say a change is required, some say maybe(?), and some say none is required. Is there a commercial source doing these swaps in PACNORWEST?
Thanks
To follow is step bed conversion to tanker duty, bed lining to wood staves(old school) driveline upgrades for tow/carry duty over mountains, and some goodies-audio, phone, variable load springs, task built ladder bar, battery move to rear, and lighting convert to led. Miss anything, probably.
But for now I need to get through the disk conversion without a swap out if possible. And I read conflicting reports about master cylinder upgrades; some say a change is required, some say maybe(?), and some say none is required. Is there a commercial source doing these swaps in PACNORWEST?
Thanks
