- Joined
- Aug 31, 2007
- Messages
- 1,756
- Points
- 3,101
- Age
- 35
- City
- Eastern Iowa
- Vehicle Year
- 86
- Transmission
- Manual
Do a 94 Explorer 8.8 and a 86 Ranger 7.5 use the same U-Joint???
Thanks
Thanks
U-Joints
- Thread starter Beef52751
- Start date
85_Ranger4x4
Wallers in rivers
TRS Forum Moderator
TRS Event Staff
Article Contributor
TRS Event Participant
TRS 20th Anniversary
VAGABOND
OTOTM Winner
V8 Engine Swap
- Joined
- Aug 7, 2007
- Messages
- 36,864
- Points
- 2,001
- City
- Frankfort
- State - Country
- IA- USA
- Vehicle Year
- 1985
- Engine
- 5.0
- Transmission
- Manual
No, the the rear of the '86s is much smaller.
- Joined
- Aug 7, 2007
- Messages
- 2,384
- Points
- 3,101
- City
- Michigan
- Vehicle Year
- 1984, 1997
- Transmission
- Manual
- My credo
- If you're not making mistakes, you're not learning.
Nope. But the locating circle of the flanges should be the same. I redrilled my 8.8" axle flange with a smaller bolt circle in between the other holes so that it would fit the smaller (older) flange on the driveshaft side.
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
