When driving and hitting bumps my door sounds loose. I went through and tightened every hinge, bolt, and screw and no difference. Anyone else have this problem, and how can i fix it? Possible new door latch? 
floppy door?
- Thread starter dancron
- Start date
- Joined
- Aug 7, 2007
- Messages
- 1,660
- Points
- 3,101
- City
- Huntington, In.
- Vehicle Year
- 1990
- Transmission
- Manual
It could be the weatherstripping is worn out. I know my doors rattled until i replaced the weatherstripping. my. 02 though
- Joined
- Feb 25, 2009
- Messages
- 3,013
- Points
- 3,101
- Vehicle Year
- 1997
- Transmission
- Manual
besides tightening everything, did you check to see if the door is out of adjustment? mine did that and i had to adjust the striker bolt a little. it's a trial-and-error kinda job.
- Joined
- Jan 17, 2009
- Messages
- 1,289
- Points
- 3,101
- City
- North Eastern Ca.
- Vehicle Year
- 1986
- Transmission
- Manual
It's the stud the door grabs when you shut it.If you loosen that you can adjust it a little bit and tighten the door as it shuts.
- Joined
- Feb 25, 2009
- Messages
- 3,013
- Points
- 3,101
- Vehicle Year
- 1997
- Transmission
- Manual
close your door slowly and look and see how and where it is contacting the striker bolt. then, when you loosen the screws for the striker bolt, it will slide around a little, front to back and up and down. just move it a fraction in the direction you think it needs to go, then tighten it back down. close your door slowly and see how it mates up to it. then close it and see if it is any tighter. like i said, trial and error. took me about a half hour to get it where i wanted it. i had all new rubber door surrounds put on and they were bigger due to the old ones being totally collapsed and useless. didn't take long to figure out i needed to adjust the doors so they would close more easily.
good luck with this.
good luck with this.
sat there for awhile and moved the striker around nut nothing really worked. took a little wire tape and but it around the contact area (because its worn) and it stopped. so i guess i should prob order new strikers
- Joined
- Aug 7, 2007
- Messages
- 2,243
- Points
- 3,101
- Age
- 54
- City
- Farmington Il.
- Vehicle Year
- 1988
- Transmission
- Automatic
There should be a plastic sleeve over the door striker. The latch is what is rattling as the strikers diameter is too small. Go to the "help" section at the local auto parts place and get some of those sleeves.
- Joined
- Aug 11, 2007
- Messages
- 18,554
- Points
- 3,101
- Age
- 70
- City
- Ontario, Canada
- Vehicle Year
- 2007
- Transmission
- Automatic
- My credo
- Love Thy Neighbor
My passenger door closes with a very nice, deep CLooonK...my driver door rattles and clops and doesn't actually close right...I farted around with the striker and actually changed the sleeve with some old pipe that just happened to fit...it now closes much better, but it still doesn't come close to the passenger side...
I had a similar problem with my Tempo and it turned out to be the hinge pins...they were allowing just enough play to make adjustments elsewhere useless...
You might tryh the striker a bit more because there actually is a sweet spot on them...if not, check the door for up and down play and look closely at the pins on the hinges...
I had a similar problem with my Tempo and it turned out to be the hinge pins...they were allowing just enough play to make adjustments elsewhere useless...
You might tryh the striker a bit more because there actually is a sweet spot on them...if not, check the door for up and down play and look closely at the pins on the hinges...
Sponsored Ad
TRS Events & Gatherings
Latest posts
-
-
-
-
-
-
-
Specific Radio Boss (note not Bose, but Boss) 632UAB
- Latest: Li'l Work Truck
-
-
-
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
