Removing body lift

SW20 FTW · Mar 15, 2011

I bought my ranger with a body lift on just the bed. I just want to remove the blocks from the bed and set it back on the frame because i dont like the look of the body lines not lining up.

I just need to know if the same bolts will work for bolting it back onto the frame. Also, stock does it come with bushings to prevent squeeks or anythings?

Thanks :icon_thumby:

91rangerstx · Mar 15, 2011

I dont think theres any bushings on the box atleast there wasnt on mind when i put my body lift on and also as long as the bolts are not too long and theres thread there to tighten them up you can use the same bolts. If not your have to get new bolts no biggy.

SW20 FTW · Mar 19, 2011

i ended up having to get shorter bolts

the beds back down but now im trying to lower the bumper, and i can only get one hole lined up.. do people turn the brackets upside down or something when they raise a bumper to match the bed? im trying to lower the bumper back down so my tailgate will open

Surrey · Mar 19, 2011

He might have used some sort of relocation brackets to raise the bumper... How much higher than stock is it?

Pictures of where its attached would really help.

SW20 FTW · Mar 19, 2011

well when i took the bed lift off, the bed pretty much sat all the way down on the frame but i couldnt open the tailgate.

the brackets were both lined up with 2 bolt bolting the bumper to the frame. after i lowered the bumper i can only get one bolt to line up but it sits at the right height. im leaning towards the bracket being flipped and/or on opposite sides. It wont be hard to figure out when i do it but im just trying to see how everyone else lowers/raises their bumpers according to what their doing.

SW20 FTW · Mar 19, 2011

the brackets do look stock by the way

06RangerXLT · Mar 25, 2011

SW20 FTW said:
the brackets do look stock by the way

if the brackets arent angled and curved steel with about 5 holes in it, they are aftermarket.

i have half my buddys old brackets turned into my light tabs on my front bumper.

SW20 FTW · Mar 27, 2011

06RangerXLT said:
if the brackets arent angled and curved steel with about 5 holes in it, they are aftermarket.

i have half my buddys old brackets turned into my light tabs on my front bumper.

angled? mine are curved but i dont think their angled

strvger · Mar 28, 2011

you did keep the body/bed bushings on didn't you? they are relatively cheap for new ones. think i paid like $50 or so for my new ones and well worth it, imho.

Removing body lift

SW20 FTW

15+ Year Member

91rangerstx

15+ Year Member

SW20 FTW

15+ Year Member

Surrey

10+ Year Member

SW20 FTW

15+ Year Member

SW20 FTW

15+ Year Member

06RangerXLT

15+ Year Member

SW20 FTW

15+ Year Member

strvger

15+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions