My Ranger is Glitching when i pull the Brights

TmoneyRanger · Feb 6, 2011

I just wired a new sub in my 93 Ranger 4wd XLT 4.0 and at first when im in the truck i pull the brights and nothing happens then after i have been listening to the music for about 15 20 min i go to pull my brights and the truck almost dies kindof like its grounding out total kill switch lol Not Good. Any ways i bought the aftermarket wireing harness made all the conections corectly any ideas also i grounded the amp buy the driver side door i noticed that there is the ground for something else near the ground for my amp????? Help Thanks Buy the way this is My FIrst Truck With Subs And I thinks Truck Bass Rocks!!!!

adsm08 · Feb 6, 2011

Check your alternator output with the audio system running. You may be overloading the generator. Also check the condition of the connections at the solenoid end of the positive battery cable. I've seen loose wires there cause the whole truck to skip a beat when any tiny little load is added to the system, bights, turns, brake lights.

ForOffRoadDriving · Feb 6, 2011

yep, check your cables and your grounds. its normal for the lights to dim when the bass hits (if you havent upgraded the battery to an 850cca, installed thicker battery cables, and a larger alternator) but for everything to hiccup like that aint right. what exactly did you ground the amp to?

My Ranger is Glitching when i pull the Brights

TmoneyRanger

10+ Year Member

adsm08

Senior Master Grease Monkey

ForOffRoadDriving

15+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions