- Joined
- Aug 6, 2007
- Messages
- 527
- Points
- 3,101
- Age
- 38
- City
- Caledonia, Ontario
- Vehicle Year
- 1990
- Transmission
- Automatic
quick question.... i know ive asked before... but i dont know if it was on the old forum, and teh search is being difficult....
cutting down a full width dana 44 axle from a 77 f-150, is it 3 inches from the long side to get it the correct size for the ranger?
Ive heard you can take so much off of the long side then you can use stock size shafts from the old broncos and it will be the correct width to go under a ranger... just need to make sure its 3 inches before i cut this thing.
Thanx
-Alex
cutting down a full width dana 44 axle from a 77 f-150, is it 3 inches from the long side to get it the correct size for the ranger?
Ive heard you can take so much off of the long side then you can use stock size shafts from the old broncos and it will be the correct width to go under a ranger... just need to make sure its 3 inches before i cut this thing.
Thanx
-Alex
