Type of terminal necessary to hook into '99 Ranger fuse panel???

[atomicjoe23]

I want to add a circuit (for power seats from a '00 Mountaineer) to my fuse panel. . .I plan on using spare fuse location #12 (because it's easiest to get to) but I need to know what type of terminal goes on the end of the wire to clip into the stock '99 Ranger fuse panel. . .

. . .also, where can I buy them from?

Thanks!!!

 

[atomicjoe23]

I found these in Waytek Wire, but I'm not sure which one is the right one. . .

http://order.waytekwire.com/productdetail2/M50/37062/MINI AUTO BLADE FUSE CLIP/

http://order.waytekwire.com/productdetail2/M50/37064/MINI AUTO BLADE FUSE CLIP/

http://order.waytekwire.com/productdetail2/M50/37065/MINI TAPPER FUSE CLIP/

http://order.waytekwire.com/productdetail2/M50/37061/AUTO-BLADE TYPE FUSE CLIP/

Thanks for any help!

 

[BRUTUS_T_HOG]

the ones in the links should match the other fuses in the panel. those push into the fuse slot and then a female spade connector plugs onto them... probably not as clean as you'd like.

i would just run power straight off the starter relay terminal with an in-line fuse holder, then run it to the seats under the interior trim/carpet.

i assume you want to tap into something that is hot at all times?

 

[atomicjoe23]

Yeah. . .hot all the time.

Thanks!

 

[BRUTUS_T_HOG]

well then i would do it just like i said. much cleaner and you'll still have easy access to the fuse.

 

[atomicjoe23]

I guess that will be easier. . .and save me time. . .

 

[bilzy7]

lol ya i was lazy too and ran it directly to battery for fulltime power... i later on plan to do the fuse box and "pretty" it up but for now.... it works..
good luck on the seats and enjoy the higher riding. i sit about 1 inch higher or so now. love it, better angles to see from.