• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Replace Bent Axle? Or rear end...


LittleFoot

Member
Joined
Oct 3, 2017
Messages
5
City
Marblehead, Ma
Vehicle Year
1993
Transmission
Automatic
First post, been lurking for a while. my 93 4wd 3.0 has 94k but the rear passenger side axle was bent in an accident. Still drivable, but I get a slight wobble at high speeds and the axle grease is leaking on my drums, so that will need to be replaced as well.

Should I go through the hassle of replacing the axle and brakes alone? Or would it just be easier to find a complete rear end?

Thanks!
 
If your housing is straight ( the axle tube/tubes could be bent ) then replace the axle & seal & perform a diff service ( if needed ) make sure your axle fluid level is correct before driving, replace the brake pads & drums ( if needed ). while the rim tire is off check the rim, it may be bent, check the tire it may have been damaged in the accident ( bubble/tread separation/belt pull ). I would also check the axle to spring mount pin, your axle could have moved forward/backward were it mounts to the spring.
 
I replaced the rim, tire, and all of the suspension and mounts. Axle swap seems easy enough, my buddy has a decent garage shop. I'll probably upgrade the drums at the same time.
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top