Welcome Visitor! Please take a few seconds and 87ranger
New Member
- Joined
- Apr 2, 2017
- Messages
- 1
- Vehicle Year
- 1987
- Transmission
- Automatic
Hey everyone
I have a 1987 ranger with 2.9l v6 2wd. I was going to swap motor but ended up replacing one of the heads. I had disconnected everything. It has been 3 years since I disconnected everything and just did the head this weekend but I tried to start it today and it wouldn't start I jumped the terminals on the solinoid and it started. Everything on there looks good. I have a black and white wire from the cab and can't remember where they go. There it's also a small block next to the solinoid with 2 terminals . Any ideas ? Also does anyone have a picture of the 2.9 with vacuum connections the manual is confusing .
Thank you
I have a 1987 ranger with 2.9l v6 2wd. I was going to swap motor but ended up replacing one of the heads. I had disconnected everything. It has been 3 years since I disconnected everything and just did the head this weekend but I tried to start it today and it wouldn't start I jumped the terminals on the solinoid and it started. Everything on there looks good. I have a black and white wire from the cab and can't remember where they go. There it's also a small block next to the solinoid with 2 terminals . Any ideas ? Also does anyone have a picture of the 2.9 with vacuum connections the manual is confusing .
Thank you
