pics requested

[chrwilkins30]

wondering if anyone has pics of a gen1 be with a 3inch body lift and bushwacker cutout flares and 33's. wondering if it would fit. and would be awesome if anyone has the look im going after.

Thanks

Edit: If no one has a picture. how much do the fenderflares open the wheel wells up.

 

[RICO9]

it would fit. i used to have a 87 b2 with a 3" body lift and 33's and i only had to cut about an inch of the back of the front wheel arch. i think those bushwhackers open up the wheel well up at least 3".

 

[chrwilkins30]

Thats awesome to hear.

Another question: what size rims should i run. I want to run a 33x10.5x15 BFG but i also want the tire to stick out about 1.5ins past the body lines. what do you recommend.

I might possible go with a 33x12.5 but not really sure yet.

Any input is good.

 

[azbronco2]

got to get the right offset wheels my 36's are on 4" backspace 15x10s and stick out about 3 1/2" past the fender on the front I tried them on stock jeep wrangler wheels and they hit the body in the rear inside and hit the swaybar and radius arms on the front they are 12.50 wide.

 

[chrwilkins30]

im thinking 15x8 with a 4inch BS. but im still not sure. i really want it to stick out some since im getting the fenderflares from summit with the next check and bed lineing the bottom of the portion of the sides.

 

[azbronco2]

I have used that rustoleum bedliner from wally world for 44 bux a gallon and had great results it don't have the rubber chunks in it its more of a sand texture and you can paint over it it is a flat black color.

 

[chrwilkins30]

anyone got input on the rim size i should use to make them stick out past the body line

 

[RICO9]

i think a 10" wide rim with about a 3" positive off-set would be just about right.

 

[RacinNdrummin]

Hahns has a 3" body lift and 34" LTB's, no suspension lift other than a mild bump from shackles. Dont be afraid to trim your fenders, B2's look better with trimmed fenders anyway...

 

[chrwilkins30]

I think im going to go with these rims. because i want aluminum and not steel.

http://www.summitracing.com/parts/MTT-1250421/?rtype=10

 

[Boggin]

i have 3" body lift and 1.5" spacers with 33x12.50s on 15x8s with i think are 3.75 backspacing. i recently put in 2" coil spacers since the front used to rub on the edge of the fenders some when turning but now they dont rub anymore with the 2" coil spacer

 

[chrwilkins30]

i know i watch your build. i just don't want to add a spacer only because if the stuff if seen and that im only driving on the road.

but wheel spacers issues ive heard is a different thread.

 

[Bennybooster]

15x8 3.5in backspace, it will stick out a bit but shouldn't kill your wheel bearings

 

[chrwilkins30]

yeah the problem is i cant find a 3.5bs thats not a ton of money and that looks good.

 

[Boggin]

i know i watch your build. i just don't want to add a spacer only because if the stuff if seen and that im only driving on the road.

but wheel spacers issues ive heard is a different thread.

by this time next week mine will be a dd too. alot of people on this site run wheel spacers and beat the shit out of them and i beat the shit out of mine and theyre still holding up fine