1994fordranger
Well-Known Member
hi everyone, quick question, when putting manual hubs in rather then the auto ones can i just swap them in and thats that? or is there more to it?
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Manual hub conversion D35
- Thread starter 1994fordranger
- Start date
- Joined
- Feb 28, 2001
- Messages
- 9,470
- City
- Dayton Oregon
- Vehicle Year
- 1990, 1997
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
- Total Lift
- 6
- Tire Size
- 35"
you have to swap over the wheel bearing lock nuts too, but that's it
dirtystanchez
Member
You will need the washer that goes between the nuts too.
Be sure to leave out the locking pin from the auto hubs when you remove them. It won't be needed.
- Joined
- Feb 28, 2001
- Messages
- 9,470
- City
- Dayton Oregon
- Vehicle Year
- 1990, 1997
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
- Total Lift
- 6
- Tire Size
- 35"
NUT AND WASHER KIT from Jim, $9 a side plus shipping with the nuts and washer
Similar threads
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Latest posts
-
-
-
2.3L ('02-'11) no engine oil on dipstick when buying used 2002 i4 ranger
- Latest: youngbuckwithapickuptruck
-
-
-
What did you do to your 2019 and up Ranger today?- Latest: Robertmangrum.rm
-
-
-
-
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
