Ignition Switch and NSS wiring diagram

[TakeTheirCoats]

Looking for wiring diagrams to help troubleshoot no crank no start condition.

(Neutral Safety Switch or Digital Transmission Range Sensor)

 

[RonD]

I posted 2001 starting diagram in this thread, PDF file: http://www.therangerstation.com/forums/showthread.php?t=166778

Same wiring as 2002 and 2003

 

[TakeTheirCoats]

I tested the New ignition switch I installed a few days ago. (I have the 'No Crank No Start No Click' thread also)

probing the Red/Lt Blue wire on the switch while turning key to 'Start' I do not get 12 volts. All the yellow wires coming in to the switch have 12 volts.

Did I buy a bad Ignition switch? or is their something else that would prevent it from putting out 12 volts?

 

[RonD]

No, nothing else
Ignition switch is a slider switch and START position is at the end of the "slide", ACC Key position is at the other end, so maybe it is not sliding far enough?
Try turning key to ACC and see if it goes all the way

The Key rotates a gear that push or pulls on the actuator rod that moves the slider in the ignition switch into its 4 positions
ACC OFF RUN START

 

[TakeTheirCoats]

Yes, it goes to all positions.

I returned the ignition switch for another one at AZ.

It now starts!

They must repackage returns! Caused me hours of troubleshooting other areas!!!