D35 Inner Axle u-joint?

[motopete]

I'm sure this has been covered somewhere but I can't find it.

What are you guys using for your D35 inner u-joint? Spicer 760? Also are you putting full circle snap rings?

It seems to be a good idea, but is it over kill?

 

[brinker88]

Both of those arent necessary, but definitely a good idea. You should also think about doing the external c-clip eliminator mod as well. All three joints are the same. The standard 297x joint or the HD 760x.

You WILL have to clearance the yoke for the full c-clip mod.

 

[4x4junkie]

http://www.therangerstation.com/Magazine/May06/dana35_ujoint_snapring.htm

http://www.therangerstation.com/tech_library/c-clip_eliminator_external.html

Don't weld on your shaft like shown in the above link though, it is completely not necessary and can weaken the shaft. A hose clamp to hold the boot in place is plenty sufficient for holding the spring also.