aknott1994
Active Member
- Joined
- Feb 17, 2020
- Messages
- 32
- City
- Michigan
- Vehicle Year
- 1992
- Engine
- 3.0 V6
- Transmission
- Automatic
My truck is leveled with taller coil springs, will I need to shorten my driveshaft?
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
D28 to D35 Driveshaft Question
- Thread starter aknott1994
- Start date
- Joined
- Feb 28, 2001
- Messages
- 9,470
- City
- Dayton Oregon
- Vehicle Year
- 1990, 1997
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
- Total Lift
- 6
- Tire Size
- 35"
I believe so, I think it's 1 1/2" shorter if memory serves but I cheated when I switched to a Dana 35 I swapped in a 1354 transfer case so I could use the stock dual cardan front shaft used with those... speaking of which, I should get a spare for good measure...
- Joined
- Oct 24, 2012
- Messages
- 4,604
- Age
- 35
- City
- Lafayette
- State - Country
- TN - USA
- Vehicle Year
- 1988
- Vehicle
- Ford Ranger
- Drive
- 4WD
- Engine
- 4.0 V6
- Transmission
- Manual
- Tire Size
- 245-70-R16
If you can find a front driveshaft from and FM-145 truck, it's already an inch shorter. Works perfectly. 
Similar threads
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Latest posts
-
2.3L ('02-'11) no engine oil on dipstick when buying used 2002 i4 ranger
- Latest: youngbuckwithapickuptruck
-
-
-
-
-
-
-
-
-
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
