c-clips

[Dangeranger3]

Can't get it em out. Have only tried pass. side but I'm so damn frustrated after a couple hours. Any tips on this? Crosspin and gears are removed, I've pushed the axle in tons of times. The clip won't fall out and I can't push/pull it out. Someone help before I burn this heap to the ground.

 

[dusto2]

you mean took the spider gears out right, try putting the 2 spiders back in place to hole the side spiders in place better than try taking th clips out

 

[Dangeranger3]

yes the spiders are removed. I got the clips out by removing the drums. It allows the axle to be slid further in (compliments of write-up not yet in tech lirary which I think the best write up)

But a new question arises. I do not have thrust washers. Is this a bad thing? And what kind of grease is acceptable for intallation? I have some brake and wheel bearing grease that is high temp. will that cause anyproblems? Instructions say "medium grease" Any help appreciated. And thank for reply Dusto

 

[Dangeranger3]

Install complete, found the thrust washers, lock rite kicks ass, thanks for reading

 

[Hahnsb2]

Install complete, found the thrust washers, lock rite kicks ass, thanks for reading

Good deal, you'll quickly find the Lock-right is one of the best investments you've made for your rig