triumphrider-1
Well-Known Member
Those look about right, but the best way to make sure their correct is to pull the existing and match the numbers off of them.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Axle Seals Front & Rear
- Thread starter MorganMcCann
- Start date
MorganMcCann
Well-Known Member
But I'm not buying Ford parts, so the numbers wouldn't be the same?
adsm08
Senior Master Grease Monkey
Supporting Member
Article Contributor
Ford Technician
TRS 20th Anniversary
- Joined
- Sep 20, 2009
- Messages
- 34,623
- City
- Dillsburg PA
- Vehicle Year
- 1987
- Engine
- 4.0 V6
- Transmission
- Manual
- Tire Size
- 31X10.50X15
Ford doesn't make it's own bearings. They frequently buy them from Timken.
MorganMcCann
Well-Known Member
So as long as I have the bearing and seal for the 7.5" rear end, I should be fine?
triumphrider-1
Well-Known Member
Should be, but it doesn't hurt to take one of each with you to match numbers.
MorganMcCann
Well-Known Member
When I do it, I'm not sure if I will have a ride to Autozone or not.
Similar threads
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
