Axle C-Clip, splined washer, end of axle..

[raggedyann]

I just installed a Dana 35 in my 87 ranger,
At the end of axle shaft that comes thru the spindle, it had a splined washer and the c-clip.
Question, is this all goes here ?
my Dana 28 has a flat washer then a flat thrust needle bearing and then another washer , then c-clip.
I don't know if someone left these off or if the 35 doesn't use them.
it has Warn manual hubs.

 

[SenorNoob]

It depends on the thickness of the washer. But, it could be all there is. That's the way mine is setup. I have a washer that's like 1/4 in. thick tho.

 

[4x4junkie]

Depending on what year the D35 is, it should have one of the following:

a single thick steel splined washer, plus the c-clip, or

a three-piece washer consisting of two steel washers (one splined) + a hard plastic (Delrin) washer between the two steels, then the c-clip.
On the latter setup, the unsplined washer goes on first, then the Delrin one, then the splined washer, then is secured with the c-clip.