Auxiliary 3 Gauge Autozone Kit

[wildbill23c]

Has anyone here installed one of these gauge sets? If so how difficult are they to install, the original multi-gauge pod in my 84 Bronco 2 only the fuel gauge works, the other 3 gauges don't work at all. Was looking into just installing one of these rather than trying to fix the PO's mess in wiring and such.

 

[BrucesBlack]

Well there Not that Hard to install , You might need some adapters to fit on the Oil Psi and the Water Temp Gauge But Over all if you can Install A Radio And or Speakers you Should be able to do this install with A Little Re search and time !

 

[wildbill23c]

Sounds good, thanks. I know the kit comes with some connections but until I get the kit I probably won't know what I need for sure. Seems pretty simple though as all the access to the sensors are easy to get to, the only issue is where to connect the wire for the voltage gauge?

 

[BrucesBlack]

For the Volt meter you can Run the wires to your Radio , Or Get a Digital Multimeter and Probe the Fuse box for Power on with the key switch is on !

 

[wildbill23c]

Ahh, ok, so it doesn't really matter what it connects to then as far as key on power makes it a lot easier. Probably going to do this gauge install here in the next week or so, I don't think its running hot but when the temp gauge just sits on the C all the time I'm pretty sure its not running cold since the heater works quite well LOL, and I'm pretty sure if I actually had no oil pressure the engine would have blown up by now after putting 250 miles on it already.