-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
94 v6 Ranger with auto hubs swap to 1980's manual hubs?
- Thread starter Natedog
- Start date
Hahnsb2
Well-Known Member
- Joined
- Aug 8, 2007
- Messages
- 4,416
- Age
- 36
- City
- Battle Ground WA
- Vehicle Year
- 88-95
- Transmission
- Manual
No an 80s RBV will have a D28 and his is a D35. You need the hubs, washers and wheel bearing nuts.
Natedog
Well-Known Member
Hahn's you're correct on that. 
Sorry I'll correct my question 
....will an early 90's D35 manual hubs and all fit? If so, what advice and/or special parts do we need?
Thinkin they will fit and that we'll still need the hubs, washers, and wheel bearing nuts...
Sorry I'll correct my question ....will an early 90's D35 manual hubs and all fit? If so, what advice and/or special parts do we need?Thinkin they will fit and that we'll still need the hubs, washers, and wheel bearing nuts...
- Joined
- Aug 19, 2001
- Messages
- 10,882
- City
- So. Calif (SFV)
- Vehicle Year
- 1990
- Engine
- 2.9 V6
- Transmission
- Manual
- Tire Size
- 35x12.50R15
If they're 27 spline D35 hubs, they should fit.
You need the hubs, and the spindle (wheelbearing) locknuts.
You need the hubs, and the spindle (wheelbearing) locknuts.
Similar threads
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
