• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

2.9 idle adjustment?


stevealvey24

Well-Known Member
Joined
Jan 9, 2011
Messages
194
Vehicle Year
1986
Transmission
Automatic
Just finished the MAF conversion and need to what the tps should be set at? Target rpms?
 
Well, 750 for auto trans, 850 for manual.

The TPS is best adjusted by voltage, not RPM though. The voltage is more accurate.
 
Last edited:
My idle screw WAS mucked with (a only a bit, it might appear?), and my TPS reads .5V at idle, can I safely mark my starting point and turn my screw a touch to bring it up to .9V? Or is this all too delicate for such a small increase? I've read that's .9V is goal starting read, but I ,like steve,want to be sure.
 
Adjust the TPS to get target voltage. Then adjust the screw to get the target RPM.

Adjusting the screw PROPERLY is a PITA. Takes about 20 minutes to go through the whole proceedure.
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top