1989 Ford Ranger 4X4 Manual transmission-Hydraulic line part issue-please advise.

[caliveltz]

I have a bad clutch hydraulic line on my '89 Ranger 4X4. I bought the only one on the Rockauto site and the one that they sent me is wrong. I am attaching images of the underhood of the truck and the wrong part. I am looking for advice on where and how i should be looking for the proper line?

Thank You
James
San Marcos, Ca

 

[jeremysdad]

zomg!one1!

Gigantic pictures.

That being said...please Ctrlc/v the part that you ordered, the part that you needed, and...as an aside...what is that middle pic of an alien brain scanner? lol

 

[jeremysdad]

Sry for being a dick previously...

Looks like you got the right parts, if you insist on relacing the line only. That being said...

http://www.partsgeek.com/gbproducts...-ykR1oEyS5R_uHqZZkQ8J3pKDo3uSaugPMaAhip8P8HAQ

Blow it up, and it shows you where the lines go.

Recommend buying the assembly.

(Wonder why they pointed the master more 'up' later? lol)

 

[enjr44]

Call rockauto and tell them your story.

 

[General X]

I don't have an answer for you but I do feel your pain as I had the same problem when I swapped an explorer trans and slave into my 94 ranger and rock auto sent me that line. Proceded to bang my head against some parts people trying to find the right line to make it work. At one point I ended up with a combination that would go together but would slowly leak as they were slightly different in size (Why?!) and they were different colors. Probably not something you'll into hopefully. Also, if you arn't aware of the bleed procedure for these ranger you will want to look it up as it's not terribly difficult but if you don't bench bleed the master correctly your clutch won't work and you'll pull your hair out trying to get the air out.

Sent from my Nexus 5 using Tapatalk