88 XLT Ranger
Member
- Joined
- Jul 23, 2010
- Messages
- 357
- Reaction score
- 0
- Points
- 16
- Age
- 61
- Location
- Pollock Pines Ca
- Vehicle Year
- 1988
- Make / Model
- ford
- Engine Size
- 2.9L
- Transmission
- Automatic
Need quick help
My 1988 Ranger 2.9l I started it up to warm it up it was running fine on its own for 20 minuts than it just died or stalled. I went to start it back up it just turns over wont start back up. I checked the fuel pressure at the rail tuned the key on pushed the nipple deal fuel sprayed out turned key off did it again fuel spayed out. I did change the computer a year and a half ago to a rebuilt one. The dist ignition sensor is a Motorcraft only 2 years old. When I crank the engine over the check engine light comes on. I never had this issue before I did notice a few times as its running it acts like its going to stall but comes back in RPM's quick
I took the cover off the computer the board looks ugly lots of pealing of clear sealer looking stuff. I seen nothing burnt or anything leaking. Its snowing here need to find the issue quick. Any help is very much appreciated
My 1988 Ranger 2.9l I started it up to warm it up it was running fine on its own for 20 minuts than it just died or stalled. I went to start it back up it just turns over wont start back up. I checked the fuel pressure at the rail tuned the key on pushed the nipple deal fuel sprayed out turned key off did it again fuel spayed out. I did change the computer a year and a half ago to a rebuilt one. The dist ignition sensor is a Motorcraft only 2 years old. When I crank the engine over the check engine light comes on. I never had this issue before I did notice a few times as its running it acts like its going to stall but comes back in RPM's quick
I took the cover off the computer the board looks ugly lots of pealing of clear sealer looking stuff. I seen nothing burnt or anything leaking. Its snowing here need to find the issue quick. Any help is very much appreciated