Still working on getting interior fixed up got drivers floor panel wire wheeled, rust converted and sprayed with bedliner up the fire wall patched all five pencil sized rust holes in the firewall. Prepped the kick panel in preparation for the new used parking brake pedal assembly, that is almost removed from doner truck but I forgot my hex driver cuz I'm an idiot lol. Removed all the wire nuts from under the hood on the ignition system, and headlights 20 of them in total, Mindblowing ineptitude. Wires al re routed and reattached. Than I moved on to the dash side wiring. Removed 12 crimp wire taps, taped all insulation breakes, spliced new wire into blower motor power wire 2 inches of bare high amp wire didnt seem safe idk why just a feeling lol. Installed better throttle cable old one was worn out would have to move throttle half way before any response than only half a pedal of throttle was available after that. Now I have full throttle yay. Replaced ignition switch with a good one, now you actually need a key lol.