Torque Monster headers

[6770shelby]

I would like to pass along how long it actually took to order and receive a set of the headers. Ordered May 30, 2021, Received November 13, 2021.

 

[fastpakr]

Pretty standard historically. Unfortunate, but it seems to consistently take him a while to produce them.

 

[lil_Blue_Ford]

From what I understand, it’s a side project to build those headers, and he usually doesn’t stock any so it depends largely on how many people are ahead of you and how much free time he has to devote to it

 

[Junglejoe]

I have talked to Bob on the phone, the owner of Torque Monster headers.. this is a side buisness for him, he works full time. He was trying to get them produced in mass, he actually welds these things together himself most of the time.

 

[svtcards]

What's so special about them?

 

[fastpakr]

What's so special about them?

For a GT40P in an SLA Ranger, they're basically the only game in town aside from the cheap imported knockoffs of their design.

 

[Junglejoe]

What's so special about them?

They are the best thing going for the 98+ coil spring trucks.(non Tortion bar) They're not just some cheap header by any means. There has been specific research and development went in to this very headers for what it is. Don't let the 1 1/2 inch primaries fool you either, out of the box these headers flow more air than 1 5/8 BBK fox body headers!
They are a beech to put on though!
AND they will NOT just bolt up to Trick flow heads

 

[Junglejoe]

Torque Monster headers with Aluminum Trick Flow 170 heads.. Looks like oh hell, but perfectly fine.There is alot of meat on the heads.I asked a tech dude and he said it will be fine. Just cosmetic. TAKE YOUR TIME AND GO SLOW GRINDING AND FITTING THE HEADER! If you cut to deep..you throw the heads away!

 

[6770shelby]

The intention of my post wasn’t meant to be positive or negative, only to give an idea of the actual lead time for project planning purposes.