• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Superlift front driveshaft #9636 dimensions


Mr. Bossley

Well-Known Member
Article Contributor
Joined
May 23, 2014
Messages
200
Reaction score
171
Location
Kelowna BC
Vehicle Year
2008
Make / Model
Ford Ranger
Engine Type
4.0 V6
Transmission
Manual
2WD / 4WD
Solid Axle Swap 4x4
Total Lift
Around 6-7"
Tire Size
38x15.5
Ive been looking everywhere for these dimensions so i could make my own driveshaft instead of buying from the superlift factory. I didnt wanna pay over $500 US when i could make one for much less. Here are the measurements for anyone wanting to do the same.

I will be using a dual cardan shaft from an explorer and a 1310 joint to cv flange adapter by Neapco. Part number N2-83-288x

 

Sponsored Ad


Sponsored Ad

Staff online

Today's birthdays

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Year


Kirby N.
2024 Truck of The Year!

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Vagabond Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Top