BackwoodsSaint
New Member
- Joined
- Dec 4, 2012
- Messages
- 51
- Reaction score
- 0
- Points
- 0
- Location
- Minnesota
- Vehicle Year
-
1994
1992
- Make / Model
- Ford
- Engine Size
- 3.0 and 4cyl
- Transmission
- Manual
Ok, so I'm doing 6 new injectors on my dad's 99 Ranger 4.0, I have everything all set and ready to go, I'm following the instructions on All-Data for replacing the injectors, which says to place them in the fuel rail and then put them in the manifold, I followed a tip online and put just a dab of clean oil on the O-rings but i still can't get the darn things in:
Is there an easier way to do this?
Is there an easier way to do this?