crazy2.9l
New Member
- Joined
- Sep 18, 2007
- Messages
- 35
- Reaction score
- 0
- Points
- 0
- Vehicle Year
-
1986 (2)
1996
- Make / Model
- Ford all ford
- Transmission
- Manual
hey, guys well ive run into a little problem i finally got around to throwing in my dana 44 high pinion. problem is i bought it off a guy and it had no spindles but he had the hub assembles. He said it was from a 79 f250 i left it full width well as my 9inch. My buddy just happened to have a spare set of spindles for a 44 so i bought them. got my leafs in today and the axle all bolted up whent to throw on breaks and hubs only to find that the spindles i got are too big for my inner wheel bearings. Any one know if Ford made a two different styles of spindles i have a feeling i got the ones for the bigger lug nut pattern. However the spindles i got fit my knuckels thiers 5 studs just the bearings for my hub assemblys dont fit them.
thanks Dave
thanks Dave