Simple swap ?

[stuntsunltd.]

I own a 2nd Gen (92) Ranger w/ 5 speed m5od transmission. My question is have any of you out there installed a shift boot and trim similar to the ones found in the 96-97's with the built in cupholders into a 2nd Gen truck? Any advice on the level of dificulty and pics would be greatly appreciated.

 

[stuntsunltd.]

Just looking to add some cup holders in my ride and this seems like the easiest way to do so and maintain a factory look, provided its a direct swap.

 

[Haywire6000]

I have a HAD a 1993 with not cup holders. I swapped in 03' seats with a cup holder. I went the long way of getting a cup holder.

 

[Mark_88]

I put one from a 96 into my 88 a long time ago...same screw pattern and all...only problem was the cup was right under the ash tray and every once in a while I would get some ashes in my coffee...not a good combination...lol