OneGoofyGuy
Member
- Joined
- Aug 19, 2017
- Messages
- 63
- Reaction score
- 5
- Points
- 8
- Location
- Ramhurst, Ga
- Vehicle Year
- 1989
- Make / Model
- Ford
- Engine Type
- 2.9 V6
- Transmission
- Manual
- 2WD / 4WD
- 4WD
- Tire Size
- 35x12.50x15
1989 Ford Ranger XLT 4wd swapped from 2.9 to 4.0
When I bought this truck there was some wires torn and eaten on the passenger side floor board. I figured that I can get another inertia switch and rewire it to the original harness. The thing is I don't have a clue what it's going to and how to remove whatever it is, so I can rewire it. I've got the part of the harness that clips in but it's more than just the wires on the inertia switch itself. I know that it's below the blower motor
When I bought this truck there was some wires torn and eaten on the passenger side floor board. I figured that I can get another inertia switch and rewire it to the original harness. The thing is I don't have a clue what it's going to and how to remove whatever it is, so I can rewire it. I've got the part of the harness that clips in but it's more than just the wires on the inertia switch itself. I know that it's below the blower motor
Attachments
-
168.7 KB Views: 106