• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Removing driver seat cover for upright section

James Morse

Active Member
Supporting Member
Joined
Aug 31, 2021
Messages
377
Reaction score
132
Points
43
Location
Roanoke VA
Vehicle Year
1999
Make / Model
Maxda B3000
Engine Type
3.0 V6
Transmission
Automatic
2WD / 4WD
2WD
Tire Size
235/75-15
It looks to me like the cover locks at the bottom by two plastic strips that engage each other. I assume one would force these apart then the cover peels up off the seat. Does this sound correct?
 


RobbieD

Well-Known Member
Joined
Aug 6, 2007
Messages
2,461
Reaction score
1,011
Points
113
Location
Georgia
Vehicle Year
1984,1990,1994
Make / Model
Ford
Transmission
Manual
2WD / 4WD
2WD
My credo
Toonces drives a Ranger . . . . just not very well.
Been forever since I had a cover off, but that sounds correct.
 

James Morse

Active Member
Supporting Member
Joined
Aug 31, 2021
Messages
377
Reaction score
132
Points
43
Location
Roanoke VA
Vehicle Year
1999
Make / Model
Maxda B3000
Engine Type
3.0 V6
Transmission
Automatic
2WD / 4WD
2WD
Tire Size
235/75-15
ok thanks. I found easiest way is use 1/8" rod as long as the seat is wide, insert it in between the locking pieces, and they come apart easily.
had broken spring, two sharp ends sticking thru the cover. Taped them generously with Gorilla tape, they should be safe. Otherwise would put out an eye (dog).
need new seat, don't think there is any way to repair broken spring. want passenger side probably, or stock replacement, but they're expensive, so, who knows when/if that ever happens.
 

Sponsored Ad


Sponsored Ad

Top