4x4TILL_I_DIE
New Member
- Joined
- Dec 6, 2008
- Messages
- 181
- Reaction score
- 2
- Points
- 0
- Vehicle Year
- 1996
- Make / Model
- ranger
- Engine Size
- 4.0
- Transmission
- Manual
I'm in the middle of replacing my odometer worm gear everything was going fine until i went to put the new worm gear on. The new worm gear i got of ebay that is made out of delrin [so it won't disintegrate like the stock one] won't fit on the shaft of the motor. It it supposed to be a press on fit or just slip right on? It's so tight i can't get it on and if I'm going to have to drill it out i want to make sure i don't drill to big.
thanks
thanks