- Joined
- Jun 13, 2016
- Messages
- 134
- Reaction score
- 40
- Points
- 28
- Location
- Connecticut
- Vehicle Year
- 1989
- Make / Model
- Bronco ii
- Engine Type
- 2.9 V6
- Engine Size
- 2.9L
- Transmission
- Manual
- 2WD / 4WD
- 4WD
- Total Lift
- 6
Quick question for ya, I wanted to take the bronco out and finally drive the thing but I noticed I do not have tail lights or brake lights. I pulled the harness from the driver's fender back to the rear of the truck..no broken wires. I also noticed that I hear a click when I press the pedal or manually actuate the switch on the pedal, the same click that I hear when I click on my hazards. I traced the sound down to what I believe is a proportioning valve on the driver's side frame, right after the fuel filter. I haven't driven this truck for months due to all the engine work I have been doing, but I do not remember that valve or whatever it is clicking when I actuated the switch. I have 12v at the pedal switch and like half a volt back at the bulb sockets. I do have hazards in the front and my headlights work just fine. All fuses seem to be fine as well.