More where do they go parts

[PanamaExpat]

Well the day is finally here and I am hoping that by the end of the day I have actually buckled the engine and transmission back together and have them nestled into the chassis. I have a small question regarding my all inclusive LUK clutch kit. In the kit is a small bag containing a spring steel retainer ring about 4 CM in diameter and a small black rubber o-ring type seal. I have looked on the net and all over the place but can not determine where these two parts go. Anyone out there care to share the solution of this great mystery?

A diagram would be most helpful.

 

[PlumCrazy]

Oring is for the hydraulic line to the slave, and the snap ring is for the throw out bearing on the slave.

-PlumCrazy

 

[PanamaExpat]

Thanks Plum... I had a feeling that's where they went but you know how it is. You only want to put it together once if you can get by with it.

 

[doorgunner]

As Ranger Sport Honduras accudentally said one time....."He have been raped"