jcook100
Member
- Joined
- Apr 5, 2019
- Messages
- 88
- Reaction score
- 10
- Points
- 8
- Location
- Salt Lake City, UT
- Vehicle Year
- 1991
- Make / Model
- Ford Ranger
- Transmission
- Manual
I recently installed the lower intake manifold gaskets on my 4.0 V6 and torqued them down to spec. The edge of the valve cover gasket surface on the lower intake manifold seems to be sitting just a hair proud of the gasket surface edge of the header. Is this a problem, or am I okay to go ahead as is? I tried fitting the manifold without the gaskets just to see the fit, and it was sitting below the edge of the header. I also noticed that the valve cover gaskets have a flexible spot right on that joint, so maybe I am okay? Would love to hear from anyone who has done this before. Thanks.
Attachments
-
144.3 KB Views: 79
-
189.7 KB Views: 79
-
249.9 KB Views: 79
-
218.4 KB Views: 79