Leak woes! Need help please!

[ericbphoto]

PCV mounts in a hole on a valve cover. No need to remove heads for that.

 

[Angie]

if you look at this diagram picture, it shows a section called pcv. figure 1... i am not sure if this is same engine.

Rebuilding the Ford 3.0L - Engine Builder Magazine

This engine came out of the Cleveland Engine Plant #2 (CEP2), originally opened in 1955 to manufacture the 361 cid truck engine. By 1985, this facility was down to 400 employees and on the verge of closing. Then in 1988, plant renovation was begun (with the 3.0L Duratec engine family on the...

www.enginebuildermag.com

ok i think I have the styles mixed up.. duratec Vrs. vulcan..... will continue plugging away here.....

 

[Angie]

This looks to be the answers?? improperly replaced seals? and or the cap leaking?

Driveability Corner | Cylinder Misfire | Coolant Temperature Sensor | MOTOR Magazine

Ford 3.0 Liter Oil Leaks At this moment, I have in my shop a 1994 3.0-liter Ford Ranger. This truck came in a while back with what appeared to be a leaky rear main oil seal. Upon removing the transmission, however, we discovered that it was actually the oil pan gasket that was the source …

www.motor.com

 

[RonD]

Yes, that's the 3.0l OHC duratec 1996 and up

And the oil separator plate needs to be installed before the heads, PCV Valve is accessible with no disassembly


Yes, those are common leak points on the 3.0l Vulcan
There is no one answer, have to check them all

 

[jrvmosjr]

Well small claims might just cost too much money. This was going to be my daily beater but so much for that. I sold it as is and told the buyer just to buy a new rebuilt motor and transmission for it.
I went ahead and bought a new f150.
Anyone have google maps and want to leave some bad reviews on this place with me!???