• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Jack Stands/Safety


bilbo

Well-Known Member
Joined
Oct 29, 2016
Messages
786
Reaction score
913
Points
93
Location
South Florida
Vehicle Year
1983
Make / Model
Ford
Engine Type
2.3 (4 Cylinder)
Engine Size
2.3L
Transmission
Manual
2WD / 4WD
2WD
Total Lift
0
Total Drop
0
I wanted to share something that happened this weekend. I was working on a car replacing rear shocks. One of the lower bolts was being stubborn so I got under the car on the creeper to work at it. When I was backing the bolt out with an impact it caught the edge of the jack stand and slid it over a little bit. The frame curved up just next to where it was resting on the stand, and when it slid the car came down on my head, which was sideways so I could see the bolt I was working at. When I put a car on stands I always use backup stand in case 'something' happens. In this case I'm pretty sure it kept me just injured and not dead as the car only dropped a couple of inches. I was able to push myself out; I'm pretty sure the muffler is what came down on my head and the rolled edge of it got me on the temple. I went to the doc after to get it checked out as it hurt like hell and thankfully no permanent damage. The rolled part mucked up the joint where my jaw bone pivots in my skull, so I can't really open my mouth far without it hurting pretty bad.

All in all, I'm extremely lucky and figured I'd share it as a reminder to think ahead as far as you can. I should have never had the car on a jack stand that was so close to where I had to work.
 


Dirtman

Former Middleweight Moss Fighting Champion
Joined
May 28, 2018
Messages
19,304
Reaction score
13,326
Points
113
Location
41N 75W
Vehicle Year
2009
Engine Type
2.3 (4 Cylinder)
Transmission
Automatic
2WD / 4WD
2WD
Total Lift
It's up there.
Total Drop
It's down there.
Tire Size
Round.
My credo
I poop in the furnace.
Glad you're OK!
 

85_Ranger4x4

Forum Staff Member
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS Banner 2010-2011
TRS 20th Anniversary
VAGABOND
TRS Event Participant
Joined
Aug 7, 2007
Messages
32,192
Reaction score
17,487
Points
113
Location
SW Iowa
Vehicle Year
1985
Make / Model
Ford
Engine Type
V8
Engine Size
5.0
Transmission
Manual
I hate jackstands, they are a necessary evil though.

Glad you are ok!
 

ericbphoto

Overlander in development
TRS Event Staff
TRS Forum Moderator
Supporting Member
U.S. Military - Veteran
TRS 20th Anniversary
VAGABOND
TRS Event Participant
GMRS Radio License
Joined
Feb 7, 2016
Messages
15,200
Reaction score
16,335
Points
113
Age
59
Location
Wellford, SC
Vehicle Year
1993
Make / Model
Ford Ranger
Engine Type
3.0 V6
Engine Size
3.0L
Transmission
Manual
2WD / 4WD
4WD
Total Lift
6"
Tire Size
35"
My credo
In theory, theory and practice are the same. In practice, they are different.
Glad you had a happy ending to this story
 

97RangerXLT

Forum Staff Member
TRS Forum Moderator
Article Contributor
TRS 20th Anniversary
TRS Event Participant
Joined
Sep 18, 2007
Messages
6,738
Reaction score
3,841
Points
113
Location
Fishers, IN
Vehicle Year
1997
Make / Model
Ford
Engine Type
4.0 V6
Engine Size
4.0
Transmission
Automatic
2WD / 4WD
4WD
Total Lift
2"
Tire Size
31"
yeesh... glad that didn't go any worse than it did. good thinking on back up plans to keep you safe. I always leave the jack under the car as well just in case my jackstands to a a Harbor Frieght imitation or I bump the car hard enough to displace one.

Like 85 says, they are a necessary evil.

stay safe man.

AJ
 

Uncle Gump

Token Old Guy
TRS Event Staff
TRS Forum Moderator
Supporting Member
VAGABOND
TRS Event Participant
Joined
Sep 17, 2018
Messages
13,691
Reaction score
13,146
Points
113
Location
Ottawa IL
Vehicle Year
2006/1986
Make / Model
Ranger/BroncoII
Engine Size
4.0L SOHC/2.9L
2WD / 4WD
4WD
My credo
Lead follow or get out of my way
This is a good time to mention again about the Harbor Freight jack stand recalls. There were two... just recently. Please go check your stands.

I'm also one that leaves the floor jack under the vehicle and in contact even when the weight is supported by the stands.

Glad this wasn't worse... lets all play it safe!
 

MikeG

Well-Known Member
Joined
Jul 15, 2020
Messages
1,353
Reaction score
752
Points
113
Location
central Texas
Vehicle Year
1997
Make / Model
B4000
Engine Type
4.0 V6
Transmission
Automatic
2WD / 4WD
2WD
Total Lift
2"
Tire Size
235/75r15
If a tire is off then putting that under the frame is a bit of a safety measure also. I never get under a vehicle without at least two jackstands. Glad you made it!
 

Dirtman

Former Middleweight Moss Fighting Champion
Joined
May 28, 2018
Messages
19,304
Reaction score
13,326
Points
113
Location
41N 75W
Vehicle Year
2009
Engine Type
2.3 (4 Cylinder)
Transmission
Automatic
2WD / 4WD
2WD
Total Lift
It's up there.
Total Drop
It's down there.
Tire Size
Round.
My credo
I poop in the furnace.
You believe in jack stands? :icon_confused:

Show me one scientific study that proves jack stands increase safety.
 

Uncle Gump

Token Old Guy
TRS Event Staff
TRS Forum Moderator
Supporting Member
VAGABOND
TRS Event Participant
Joined
Sep 17, 2018
Messages
13,691
Reaction score
13,146
Points
113
Location
Ottawa IL
Vehicle Year
2006/1986
Make / Model
Ranger/BroncoII
Engine Size
4.0L SOHC/2.9L
2WD / 4WD
4WD
My credo
Lead follow or get out of my way
You believe in jack stands? :icon_confused:

Show me one scientific study that proves jack stands increase safety.
Show me a study that says using jack stands are worse then using no jack stands...
 

sheep herder

Well-Known Member
U.S. Military - Veteran
Joined
Nov 7, 2019
Messages
1,403
Reaction score
1,024
Points
113
Location
sheep pen
Vehicle Year
2011
Make / Model
Ford Ranger
Engine Type
4.0 V6
Transmission
Automatic
2WD / 4WD
2WD
My credo
If it ain't broke, break it.
I just use my anti-gravity machine to work under a vehicle.
 

snoranger

Professional money waster
TRS Event Staff
TRS Forum Moderator
Supporting Member
Article Contributor
RBV's on Boost
ASE Certified Tech
VAGABOND
TRS Event Participant
GMRS Radio License
Joined
Nov 25, 2007
Messages
13,052
Reaction score
13,522
Points
113
Location
Jackson, NJ
Vehicle Year
'79,'94,'02,'23
Make / Model
All Fords
Engine Type
2.3 EcoBoost
Transmission
Automatic
2WD / 4WD
4WD
My credo
I didn't ask for your life story, just answer the question!

Saddle Tramp

Well-Known Member
Supporting Member
Joined
Apr 3, 2019
Messages
790
Reaction score
745
Points
93
Location
Florida
Vehicle Year
2011
Make / Model
Ford Ranger
Engine Type
4.0 V6
Transmission
Automatic
2WD / 4WD
2WD
Glad you're alive and able to tell us this. I'm starting to think of getting a few bags of cement and letting them harden so I can shove them under the frame as a backup for the jackstand.
 

adsm08

Senior Master Grease Monkey
Supporting Member
Article Contributor
Ford Technician
TRS 20th Anniversary
Joined
Sep 20, 2009
Messages
34,623
Reaction score
3,613
Points
113
Location
Dillsburg PA
Vehicle Year
1987
Make / Model
Ford
Engine Type
4.0 V6
Engine Size
4.0
Transmission
Manual
2WD / 4WD
4WD
Tire Size
31X10.50X15
You believe in jack stands? :icon_confused:

Show me one scientific study that proves jack stands increase safety.
I own jack stands. I rarely use them. Mostly only if I need more than one corner up at a time, or if I know it will need to be off the ground for an extended period of time.

I understand the excessive stresses holding the vehicle for an extended period of time put on a jack's hydraulics. I have also had more jack stands give out and let the vehicle fall than I have jacks.
 

scotts90ranger

Well-Known Member
RBV's on Boost
Joined
Feb 28, 2001
Messages
7,925
Reaction score
4,227
Points
113
Location
Dayton Oregon
Vehicle Year
1990, 1997
Make / Model
Ford
Engine Type
2.3 (4 Cylinder)
Engine Size
2.3 Turbo
Transmission
Manual
2WD / 4WD
4WD
Total Lift
6
Tire Size
35"
I have a hard time making jack stands useful when they're not just supporting the rig by the axle tube... even with the 6 ton stands it takes like a foot of wood blocks under them to get to the frame rails on a couple rigs to get them to ride height...
 

sgtsandman

Aircraft Fuel Tank Diver
TRS Forum Moderator
U.S. Military - Active
TRS 20th Anniversary
TRS Event Participant
Ham Radio Operator
GMRS Radio License
Joined
Mar 11, 2017
Messages
12,695
Reaction score
12,380
Points
113
Location
Aliquippa, PA
Vehicle Year
2011/2019
Make / Model
Ranger XLT/FX4
Engine Size
4.0 SOHC/2.3 Ecoboost
2WD / 4WD
4WD
Total Lift
Pre-2008 lift/Stock
Tire Size
31X10.5R15/265/65R17
I’m glad you are ok.

I hate using the frame with jack stands because of exactly what you described. Like others have mentioned, I leave the jack under the truck when I can as well. Partly as a back up and partly because it takes more work to move the jack and put it back later.
 

Sponsored Ad


Sponsored Ad

Staff online

Members online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Kirby N.
March Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top