• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Electronic 4 wheel drive pushbutton overhead interior console removal


IIBRONCOS

Member
Joined
Jan 24, 2017
Messages
134
Reaction score
10
Points
18
Location
AZ
Vehicle Year
1988
Make / Model
Ford
Engine Size
2.9
Transmission
Automatic
I have pulled on it, yanked on it, looked for some type of attaching hardware and cannot remove the overhead electronic console for the 4 wheel control inside my 1988 Bronco II.
I would appreciate any insight you may have.
 


adsm08

Senior Master Grease Monkey
Supporting Member
Article Contributor
Ford Technician
TRS 20th Anniversary
Joined
Sep 20, 2009
Messages
34,623
Reaction score
3,613
Points
113
Location
Dillsburg PA
Vehicle Year
1987
Make / Model
Ford
Engine Type
4.0 V6
Engine Size
4.0
Transmission
Manual
2WD / 4WD
4WD
Tire Size
31X10.50X15
Use a small screw driver to pry forward and down on the notches in the map light lenses. Once the lenses are out you will see two screws. Remove the screws, pull the rear of the over head console down about an inch, then push the whole thing forward to release the front clips.
 

IIBRONCOS

Member
Joined
Jan 24, 2017
Messages
134
Reaction score
10
Points
18
Location
AZ
Vehicle Year
1988
Make / Model
Ford
Engine Size
2.9
Transmission
Automatic
I appreciate the quick response and will give it a try. Thanks
 

Sponsored Ad


Sponsored Ad

Staff online

Today's birthdays

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Kirby N.
March Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top