- Joined
- Apr 25, 2020
- Messages
- 20
- Reaction score
- 0
- Points
- 1
- Location
- Kingsport TN
- Vehicle Year
- 99
- Make / Model
- Ford Ranger
- Engine Type
- 3.0 V6
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
this is on rear axles
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
driveline whine
- Thread starter machinistmike
- Start date
Dirtman
Former Middleweight Moss Fighting Champion
- Joined
- May 28, 2018
- Messages
- 19,304
- Reaction score
- 13,326
- Points
- 113
- Location
- 41N 75W
- Vehicle Year
- 2009
- Engine Type
- 2.3 (4 Cylinder)
- Transmission
- Automatic
- 2WD / 4WD
- 2WD
- Total Lift
- It's up there.
- Total Drop
- It's down there.
- Tire Size
- Round.
- My credo
- I poop in the furnace.
There's always some in and out play of the axle shafts. Its just the nature of a c-clip style differential, nothing is there to actually tighten the axles down. 1/4" would be on the high end of that though. Probably worth popping the cover off to have a look...
- Joined
- Apr 25, 2020
- Messages
- 20
- Reaction score
- 0
- Points
- 1
- Location
- Kingsport TN
- Vehicle Year
- 99
- Make / Model
- Ford Ranger
- Engine Type
- 3.0 V6
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
had the chance to work on truck today. ended up replacing both rear bearings and seals. also found pinion shaft seal was bad which we replaced. still have a roar but not as bad. any other suggestions?
- Joined
- Apr 25, 2020
- Messages
- 20
- Reaction score
- 0
- Points
- 1
- Location
- Kingsport TN
- Vehicle Year
- 99
- Make / Model
- Ford Ranger
- Engine Type
- 3.0 V6
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
explained problem to repair shop and they seem to think i have worn ring and pinion. more updates when i get those replaced
- Joined
- Apr 25, 2020
- Messages
- 20
- Reaction score
- 0
- Points
- 1
- Location
- Kingsport TN
- Vehicle Year
- 99
- Make / Model
- Ford Ranger
- Engine Type
- 3.0 V6
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
here wasmy main problem. had to grind part of a tooth on new ring gear toget pin out enough to install c clips. once i got it together its quiet once again
Attachments
Sponsored Ad
Sponsored Ad
Staff online
-
97RangerXLTForum Staff Member
Today's birthdays
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Truck of The Month
Shran
April Truck of The Month
Recently Featured
Follow TRS On Instagram
TRS Events
25th Anniversary Sponsors
Check Out The TRS Store
Sponsored Ad
Sponsored Ad
Sponsored Ad
Amazon Deals
