RangerNielsen
Member
- Joined
- Mar 10, 2013
- Messages
- 280
- Reaction score
- 0
- Points
- 16
- Location
- Issaquah, Washington
- Vehicle Year
- 1994
- Make / Model
- Ford
- Engine Size
- 3.SLOW V6
- Transmission
- Manual
shit... The rotor had races in it, so I figured all was well... guess not. time for another $80 for bearings... (these ones only have ~200 miles on them...
I have checked the tab on the washer before assembling, and it does not appear to be able to pop out of the groove, so I figured all was well, but re assembling it this most recent time, it moved quite a bit.
I finally got the axle out, (see pictures) and my spindle is FUBAR'd it looks like. perhaps not though.
What is a good tightness to put the inner nut if an inch pound torque wrench is not available?
Well
I have checked the tab on the washer before assembling, and it does not appear to be able to pop out of the groove, so I figured all was well, but re assembling it this most recent time, it moved quite a bit.
I finally got the axle out, (see pictures) and my spindle is FUBAR'd it looks like. perhaps not though.
What is a good tightness to put the inner nut if an inch pound torque wrench is not available?
Well